Jul 15, 2011; 14:18
Jon Davidson
Height of Text boxes
Hi all,
I'm running Filemaker Pro Advanced 11. I've been working with filemaker since version 4. My questions feels like a newby question, perhaps it's age.
At any rate here is my question:
Is it possible to adjust the size of text boxes to smaller sizes (heights)?
i.e. a new text box created using arial 10 shows a height of 24 pixels in the inspector. If I change the height to 20 and then tab out the 24 pixel minimum comes back.
The inspector does not accept numbers for text boxes below certain levels. I'm finding it increasingly frustrating not being able to make the height of a text box to be smaller.
I've tried lower the font size to 6 which does allow for smaller boxes (pixel size to 20), but when I raise the font size to 10 the box get bigger than I wish(back to 24 pixels).
I sure it's a simple fix but I can't figure it out.
Thanks for your time in advance.
Jon Davidson
H: 315 655 2690
B: 315 655 9482
Cell: 315 655 3027
fax : 206-600-6808
Jon Davidson
#############################################################
This message is sent to you because you are subscribed to
the mailing list <fmpro@lists.lassosoft.com>.
To unsubscribe, E-mail to: <fmpro-off@lists.lassosoft.com>
To switch to the DIGEST mode, E-mail to <fmpro-digest@lists.lassosoft.com>
To switch to the INDEX mode, E-mail to <fmpro-index@lists.lassosoft.com>
Send administrative queries to <fmpro-request@lists.lassosoft.com>